Crank Brothers Stamp 3 Gen 2 Alloy Pedals

For 2020 Crank Brothers went back to the drawing board and redesigned the rider favourite Stamp 3 from 2018. Gone is the forged (6061-T6) alloy body, which has been replaced with a new lighter (AM60B) magnesium pedal body – compared to the original, this change alone has knocked off over 100g per pair!

Crank Brothers have also put a lot of thought into the bearings and seal system used in these pedals. The Stamp 3 spins on IGUS inboard bearings with double cartridge outboard bearings for increased durability and corrosion resistance. An internal seal stops unwanted contaminants from entering the pedal and the forged Chromoly steel axle means these pedals will take any beating you can throw at them!

Who’s this item for: Any riders looking for a lightweight pedal, suitable for trail, Enduro and downhill use.

Dimensions and Weight:

Small Platform

• 100mm W x 100mm L x 16mm H
• 351g/pair
• Recommended for shoe sizes 5-10 (US)

Large Platform

• 114mm W x 111mm L x 16mm H
• 386g/pair
• Recommended for shoe sizes 10-15 (US)

Bearings: IGUS inboard bearings with double cartridge outboard bearings.

Pin Quantity: 10 pins per side.

Materials: AM60B Magnesium alloy construction with a forged SCM 415 Chromoly steel axle.

Pros: Lightweight magnesium construction and comes in two sizes to fit a variety of shoe sizes.
Cons: This pedal isn’t serviceable, but it does come with a 5year warranty from Crank Brothers to keep your mind at ease.