If you own the original OneUp Components EDC Compatible Stem this kit will let you run the EDC Tool in your fork without the need to tap a thread in your steerer.
The kit is only for use with the Original OneUp Components EDC Compatible Stem with the headset preload slot on the side below the pinch bolts. It does NOT work with the new OneUp stem, or any other stem.
See images of the original EDC Stem for reference.
This kit uses a unique, conical spacer and collar to tighten down your headset, so you will need to remove your star nut.
The kit also includes proprietary steerer tube spacers that go ABOVE the stem only. They clip onto the stem and into each other to cover the distance from the stem to the top of your steerer tube. The cap then goes over that to hold your EDC Tool in your steerer tube.
In the box:
- Preload collar
- 1x preload collar bolt, M3
- 1x preload collar lock nut
- Preload conical spacer
- 2x 5mm EDC spacers
- 2x 10mm EDC spacers
- EDC top cap
Please bear in mind, installation is a complex process. Detailed instructions are available under the Links & More Info tab, please pay very close attention to them.

























Reviews
There are no reviews yet.